Subsea Components

Each piece of the lane.

The parts that make up a subsea line lane, from the bundle on the seabed to the tie-in at the shore and the platform.

From the bundle to the tie-in.

The land components are the parts of the viaduct and towers. These are the parts of the subsea lane. Each is built to the one standard, so every lane uses the same pieces.

Status: draft. Demonstrative, not detailed design. Sizes and layouts are indicative.

The parts

ComponentWhat it doesDrawingBasis
Carrier pipe (bundle)Holds the lines of a lane together as one bundle007-01Oilfield pipeline bundlesA
Wire armour and outer sheathProtects the bundle; added at sea on the centre lay vessel007-02Armour is applied in the factory today; armouring at sea is an MMC proposal
Burial and rock coverProtects the lane from anchors and fishing gear007-01About 150–200 cable faults a year worldwide, most from fishing and anchorsE
TowheadEnds the bundle and splits it into lines007-01, 007-04Subsea structures in oil and gasK
Near-shore manifoldOne per landfall; two complete tie-ins; lines to land sized for both007-04Subsea manifolds in oil and gasK
ConnectorsValve and jumper (water, fuel); branching unit (fibre); wet-mate to 36 kV (power); HVDC to develop007-04Connection at each slot
Protection structureCovers the manifold and towheads007-04MMC proposal
J-tubesCarry each line up the platform jacket to the tie-in deck007-06Standard on offshore platforms

Vessels and sea platforms are on Subsea Equipment.

Sources

  1. A · Subsea 7, Wick pipeline bundle fabrication site
  2. E · International Cable Protection Committee, media factsheet
  3. K · Oilfield Wiki, subsea structures and equipment

Subsea engineering: Build · MM Lines · Models · Components · Equipment · Drawings · Undersea Lanes (hubs and maps)